1-205 Compression Latch



  • Compression latch in two different versions
  • Compression 7mm
  • Version A: the H-dimension can be adjusted on the square threaded rod with the included nuts by +/- 20mm
    Use of cams c)
  • Version B: the H-dimension can be varied via the cranking of the cams
    Use of cams d)
  • The cams can be installed in four positions by rotating them 90°
  • IP65 according to DIN EN 60529 with: flat seal 200-0902


  • Compression latch: zinc die, black or zinc plated
  • Square threaded rod, shaft and cams: steel, zinc plated


Installation with blind rivets or screws.

1. Compression 7mm
2. Open position
3. Cam behind the locking surface
4. By folding of the handle the cam is tightened at the locking surface
5. Lockable with padlock

Compression Latch.

More Information
Material Zinc-die
Type of Latch Compression